Error Log Display (Elog) - Panasonic KX-TVS125 Installation Manual

7.2 UTILITY COMMANDS
7.2.6

Error Log Display (ELOG)

Use the ELOG command to diagnose VPS problems. Selection of this command will display
an error log.
COM. Communication error between CPU and DSP
DATA Process error of voice data
MEM. Memory error
PRG. Program error in CPU card
R/W Read/Write error of Hard Disk
Type ELOG, then Press RETURN.
$ ELOG
Note
The following tables display and explain the errors that the system can identify.
Table 7-2 Device Error Log Indications
CPU
CLOCK
DISK
DSP*
DSP*
CPU
* = Port number (KX-TVS125: 1-6; KX-TVS225: 1-12; KX-TVS325: 1-24)
208 Installation Manual
DEVICE ERROR
1. CPU MEM-GET
2. CLOCK
3. DISK DATA R/W (xx:yyyy)
4. DSP* SCAN
5. DSP* FIFO
6. CPU APPLICATION (x)
* = Port number (KX-TVS125: 1-6; KX-TVS225: 1-12; KX-TVS325: 1-24)
Indication
MEM-GET
DATA R/W (xx:yyyy)
SCAN
FIFO
APPLICATION (x)
TIME
JUL-14 2:00 PM
JUL-14 2:00 PM
JUL-14 2:00 PM
JUL-14 2:00 PM
JUL-14 2:00 PM
JUL-14 2:00 PM
Meaning
CPU board software memory acquisition error.
CPU board is short of memory temporarily
because of too much traffic.
Clock access error. Clock IC is out of order.
Check the hardware.
HDD access error. If there is a sector that often
causes errors, check the disk.
xx : IDE error code
yyyy : read/write error sector number
DSP-SCAN error. DSP is out of order. Check the
hardware.
DSP/FIFO error. During the system is handling
calls, there is something wrong with DSP and FIFO
memory temporarily.
Application error. While the system is handling
calls, temporary application error occurs.
x: port number