Remote Programming (Kx-Tvs325 Only) - Panasonic KX-TVS125 Installation Manual

7.4 REMOTE PROGRAMMING (KX-TVS325
Only)
There are 2 methods available for VPS programming:
• Method 1—On-Site Programming Using RS-232C
Connect the programming terminal with a serial cable with an RS-232C connector to the
VPS (see 2.8 TERMINAL CONNECTION).
• Method 2—Remote Programming
You can perform programming and maintenance from a remote location by accessing the
internal modem card.
This section provides important information about Remote Programming.
Below is an example of the display that will appear when you access the VPS from a remote
location.
Screen output:
Atdt91234567
CONNECT 33600/LAPM/NONE
Terminal Connected
Enter the Administrator Password :=
Please Select Your Terminal Type.
1. ASCII TERMINAL
2. VT100
Please Enter the Number :=
If the access to the internal modem of the VPS is successfully established, the display will
show "Terminal Connected" as in the example above.
The maximum data transfer rate of the internal modem is 33600 bps.
When you access from a remote location, keep in mind the following:
1.
You cannot perform the On-Site Programming and Remote Programming at the
same time.
If you try to establish remote access while On-Site Programming is in progress, the
access will be denied and the display will show "Another Terminal Connected".
To establish remote access, the screen for the System Administrator using the RS-232C
connection must be as below:
>
Likewise, access via RS-232C will be denied while remote access is established; the
display will show the same message, "Another Terminal Connected".

7.4 REMOTE PROGRAMMING (KX-TVS325 Only)

Installation Manual 233