Table of Contents
Advertisement
7.2 UTILITY COMMANDS
7.2.18 Circuit Condition Display (LMON)
Use the LMON command to display the circuit condition every 1.5 s. To turn off this command,
enter [\].
The following circuit conditions may be displayed.
"Ready"
"Incoming Call"
"Outgoing Call"
"DSP Reset"
"PT connect"
"Error"
$ LMON
No.:
10:
11:
12:
Note
The maximum number of ports depends on the VPS model.
7.2.19 Touchtone Information Display (PUTD)
Use the PUTD command to display the touchtones the VPS receives and sends.
In addition to the touchtones, the following will be displayed—the Incoming Call Service (Voice
Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time periods
that the ports are enabled.
Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The default
setting of this mode for all ports is "OFF".
$ PUTD
Target Port : * * * * * * * * * * * * * * * * * * * * * * * *
Don't leave enabled after troubleshooting.
$
To change the mode from "PUTD" to "OFF", Type PUTD again.
218
Installation Manual
: Possible to serve
: Processing arrival service
: Processing sending service
: Processing DSP reset disposition
: Processing PT connect disposition
: DSP Card is not loaded
Status
No.:
1:
Ready
13:
2:
Ready
14:
3:
Ready
15:
4:
Ready
16:
5:
Ready
17:
6:
Ready
18:
7:
Ready
19:
8:
Ready
20:
9:
Ready
21:
Ready
22:
Ready
23:
Ready
24:
Status
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Error
Advertisement
Table of Contents
Troubleshooting
