Using Forms Adjust - Intermec EasyCoder 3400 User Manual

Using Forms Adjust

3400, 3440, and 3600 Bar Code Label Printer User's Manual
4 Press and hold the Feed/Pause button while turning on the printer. The
printer prints the hardware configuration label.
5 In the top bank of the Test and Service DIP switches, turn on switches
1 and 3 and turn off switch 2.
6 Use the table below to help you choose the appropriate DIP switch
settings:
Setting
Emulation 10 mil
Emulation 15 mil
Advanced 5 mil
(default)
Advanced 2.5 mil
(default on 3440)
7 To enable 10 mil emulation, turn on DIP switch 4 and turn off DIP
switch 5.
To enable 15 mil emulation, turn on DIP switches 4 and 5.
To enable 5 mil Advanced mode, turn off DIP switches 4 and 5.
To enable 2.5 mil Advanced mode, turn off DIP switch 4 and turn on
DIP switch 5.
8 Press the Feed/Pause button.
The printer prints out the software configuration label. Verify that the
label states the correct mode.
9 Turn the printer off and then on.
10 Download the 86XX formats, fonts, and graphics from the host to the
printer.
If your label prints too close to one edge, you can reposition it by using the
X Forms Adjust and Y Forms Adjust features. The X forms adjust controls
the position of the printing area along the length of the label. The Y forms
adjust controls the position of the printing area along the width of the
label.
The following figure shows the default X and Y origins. You can control
the default X origin (top of form) with the PrintSet software or with the
Test and Service DIP switches. You can control the default Y origin with
the DIP switches only.
Chapter 6— Using Test and Service Mode
Description
The printer emulates an 8636 or 8646 printer printing
multiples of 10 mil (0.01 inch) drag and 10 mil (0.01 inch)
picket bar codes.
The printer emulates an 8636 or 8646 printer printing
multiples of 10 mil (0.01 inch) drag and 15 mil (0.015
inch) picket bar codes.
The printer uses the 3400 and 3600 command set and
prints in multiples of 5 mil (0.005 inch) drag and 5 mil
(0.005 inch) picket bar codes.
The printer uses the 3440 command set and prints in
multiples of 2.5 mil (0.0025 inch) drag and 2.5 mil (0.0025
inch) picket bar codes.
65