D-Link DES-6300 User Manual page 211

Modular L3 Ethernet Switch User's Guide
5. Complete the IPX RIP Parameters window fields if required.
6. Click . Close the IPX RIP Parameters window. The IPX Router Interface
Parameters Edit window opens.
7. Click the SAP Parameters button to modify IPX SAP parameters. The IPX SAP
Parameters window opens:
The IPX SAP Parameters window displays the following parameters:
Update Interval – SAP periodic update interval, in seconds. Set to 0 to disable
periodic messages. When set to 0, all entries learned on this interface are not aged
out.
Age Multiplier – Holding multiplier for information received in SAP periodic
updates. This value multiplied by the update interval defines how many seconds
SAP information remains without being refreshed. Set to 0 to prevent the entries
learned on this interface from being aged out.
Respond to Get Nearest Server – Defines whether the device responds to SAP
"get nearest server" requests received on this circuit.
Status – Defines whether the SAP interface is active. OFF is inactive but not
deleted.
Note: The Update Interval multiplied by the Age Multiplier must be less than 2 million
8. Complete the IPX SAP Parameters window fields if required.
9. Click. Close the IPX SAP Parameters window. The IPX Router Interface
Parameters Edit window is displayed.
10. Edit the fields.
11. Click .
12. Close the IPX Router Interface Parameters Edit window. The IPX Router Interface
Parameters window opens.
Figure 6- 159. IPX SAP Parameters window
202