D-Link DES-6300 User Manual page 206

Modular L3 Ethernet Switch User's Guide
Multicast – Indicates that the route was explicitly added to the multicast
•
RIB by the routing protocol.
IPM Route Next Hop
The IPM Route Next Hop window contains information regarding the next-hop for forwarding
multicast packets on outgoing interfaces. Each entry in the IPM Route Next Hop table refers to
the next-hop of a specific source to a specific multicast group address.
To display the IPM Route Next Hop table:
Select Router > IPM > IPM Routing > Route Next Hop Table. The IPM Route Next Hop
table opens:
The IPM Route Next Hop window displays the following fields:
Group – Identifies the IP multicast group from which the multicast packet is
being forwarded.
Source – Identifies the source IP address of the multicast packet being forwarded.
Source Mask – Masks all or part of the source IP address.
IfIndex – Identifies the port number of the next-hop.
Next Hop Address – Indicates the IP addresses of the next-hop. This may be
identical to the Group value. However, some ports may have multiple next-hop
addresses from a single outgoing interface.
State – Indicates if the port and next-hop are being used to forward multicast
packets. The possible values are:
Pruned – The port and next hop are not being used to forward multicast
•
packets.
Figure 6- 154. IPM Route Next Hop window
197