D-Link DES-6300 User Manual page 138

Modular L3 Ethernet Switch User's Guide
interface. Possible values are between 3 seconds and the maximum interval
defined above. Default value is 0.75 of the Maximum Interval.
The Advertisements Life-Time—Indicates the maximum time (seconds) the
advertised addresses are considered valid. Must be no less than a Maximum
Interval defined above, and no greater than 9000 seconds. Default value is 0.3 of
the Maximum Interval.
Advertise This Interface—Indicates whether the address is advertised.
The Preference Level of this Address—Indicates the preference address as a
default router Default address, relative to other router addresses on the same
Subnet.
Change all parameters to—Resets all parameters in this window to their default
values.
To edit RIP Parameters window fields:
1. Display the RIP Interface Table (Select Router > IP > RIP > Interface Parameters).
2. Select an entry in the table.
3. Click . The RIP Interface Table Edit window opens.
4. Edit the selected table entry fields and click
5. Click . When the Status field displays "Finished!", the fields are confirmed as
modified.
To display the OSPF Interface Table Edit window:
OSPF is supported from software version 3.03 and up.
Figure 6- 90. RIP Interface Table Edit window
129
. The RIP Interface Table opens.