D-Link DES-6300 User Manual page 153

Modular L3 Ethernet Switch User's Guide
Figure 6- 103. OSPF Interface Table Edit window
The OSPF Interface table Edit displays the following additional parameters:
Admin Status – The OSPF administrative status in the router. Enabled means
that the OSPF process is active on at least one interface. Disabled means the
process is not active on any interface.
Priority – The priority of this interface. The value 0 means that this router is not
eligible to become the designated router on the current network. If more than one
router has the same priority, the router ID is used.
Hello Interval (sec) – The amount of seconds between Hello packets. All routers
attached to a common network must have the same Hello Interval.
Time Before Declare Router Dead (sec) – The number of seconds a router Hello
packet has not been detected, before the router neighbors declare the router to be
down. The value must be a multiple of the Hello Interval value. All routers
attached to a common network must have a value specified for this parameter.
Interface Authentication Key – The interface authentication key.
Authentication Type – The interface authentication type. For example, a
password could be used for authentication.
144