D-Link DES-6300 User Manual page 150

Modular L3 Ethernet Switch User's Guide
The OSPF Parameters window displays the following fields:
Administrative Status – The OSPF administrative status in the router. The field
options are the following:
Enable – The OSPF process is active on at least one interface.
•
Disable – The process is not active on any interface.
•
Router ID – The router ID number. To ensure uniqueness the router ID must be
equal to one of the router IP addresses. By default, the router ID takes the IP
Interface Address. Reset the device to allow changes in the router ID to take effect.
Number of External LSAs – The number of external Link-State Advertisements
in the link-state database.
External LS Checksum Sum – The sum of LS checksums of external LS
advertisements contained in the LS database. Use this sum to determine if there
has been a change in a router LS database, and to compare the LS database of two
routers.
Leak RIP Routes – Controls the route redistribution from RIP into OSPF. When
this parameter is enabled, all routes inserted into the IP routing table via SNMP are
advertised into OSPF as external routes.
Controls route redistribution from static routes to RIP. When this parameter is
enabled, all static routes learned via static are advertised into RIP.
Controls direct route redistribution that is external to OSPF into OSPF. If this
parameter is enabled all external routes are advertised into OSPF as external
routes.
Figure 6- 101. OSPF Parameters window
141