D-Link DES-6300 User Manual page 139

Modular L3 Ethernet Switch User's Guide
1. Display the IP Router Interface Parameters Edit window.
2. Press the OSPF Parameters button. The OSPF Interface Table Edit window opens:
Figure 6- 91. OSPF Interface Table Edit window
The OSPF Interface Table Edit window displays the following fields:
IP Address – The IP address of this OSPF interface.
Area ID – The IP address of the area.
lf Type – The interface type, such as Broadcast.
Admin. Status – The administrative status of the OSPF in the router. Enabled
means that the OSPF process is active on at least one interface. Disabled means the
process is not active on any interface.
Priority – The priority of this interface. The value 0 means that this router is not
eligible to become the designated router on the current network. If more than one
router has the same priority, the router ID is used.
Hello Interval (sec) – The amount of seconds between Hello packets. All routers
attached to a common network must have the same Hello Interval.
Time Before Declare Router Dead (sec) – The number of seconds a router's
Hello packets have not been detected, before the router's neighbors declare the
router to be down. The value must be multiple of the Hello Interval value. All
routers attached to a common network must have a value specified for this
parameter.
lf State – The OSPF interface state:
Down – The OSPF interface is down.
•
Loopback – The OSPF interface is in the Loopback state.
•
130