Copy Denst. Adj; Send/Box Density; Backgrnd Density; Autocolorcorrect - Kyocera ECOSYS M6026cdn Type B Operation Manual

AutoColorCorrect

This setting allows you to adjust the detection level used by the machine to determine whether the original is
color or black and white during Auto Color Mode. Setting a lower value will result in more originals being
identified as color, while a larger value will tend to increase the number of originals being identified as black and
white.
Use the procedure below to set the Auto Color Detection Level.
Sys. Menu/Count.:a b
;
Document Box
<
Edit Destination
=
*********************
Adjust/Maint.
Adjust/Maint.:
1
*********************

Copy Denst. Adj.

2

Send/Box Density

3

Backgrnd Density

AutoColorCorrect: a b
1 *********************
5
2
4
3
3

ColorCalibration

This machine contains a calibration function that automatically makes adjustments to compensate for changes
that occur over time due to variations in the ambient temperature and humidity. So that the highest quality color
printing can be maintained, this color calibration operation is carried out automatically each time the power to
the machine is turned on. If color tone does not improve or color drift does not improve after executing this color
adjustment, perform color print position correction on page 8-127.
1
[ Exit ]
2
a b
[ Exit ]
3
4
5
6
8-126
Default Setting (System Menu)
In the Sys. Menu/Count. menu, press the  or 
key to select [Adjust/Maint.].
Press the OK key. The Adjust/Maint. menu
appears.
Press the  or  key to select [AutoColorCorrect].
Press the OK key. AutoColorCorrect appears.
Press the or  key to select a value from [5] to
[1].
Press the OK key. Completed. is displayed and the
screen returns to the Adjust/Maint. menu.