LAN Interface:
1 *Auto
*********************
2
10Base-Half
3
10Base-Full
TCP/IP (IPv4) Setup
Set up TCP/IP to connect to the Windows network.
Refer to Network Setup (LAN Cable Connection) on page 2-15 about the procedures.
TCP/IP (IPv6) Setup
Set up TCP/IP (IPv6) to connect to the network. The default setting is Off.
Use the procedure below to setup the TCP/IP (IPv6) setting.
Sys. Menu/Count.:a b
1
Report
2
Counter
3
*********************
System/Network
Login User Name: L b
*******************
Login Password:
5
6
a b
7
8
1
[ Exit
]
[ Login
]
8-175
Default Setting (System Menu)
Press the or key to select [LAN Interface].
Press the OK key. LAN Interface appears.
Press the or key to select the desired LAN
interface.
The available LAN interfaces are as follows:
Auto
10Base-Half
10Base-Full
100Base-Half
100Base-Full
1000Base-T
Press the OK key. Completed. is displayed and the
screen returns to the Network Setting menu.
In the Sys. Menu/Count. menu, press the or
key to select [System/Network], and press the OK
key.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the Login User Name and Login
Password to log in, and press [Login] (the Right
Select key).
8