Callback To Cell Phone; Figure 2-31 Example - Callback To Cell Phone - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

When using Mobile Extension in a NetLink Network, the ISDN/PRI must be utilized in the

Primary System (Version 3100 or lower software).

With Version 4000 or higher software, when using Mobile Extension in a NetLink Network,

the ISDN/PRI can be utilized in the Secondary systems.

Mobile Extension and UCB (Unified Communications for Business) are not supported

within the same system (UCB 5.0 SP4, TSP 3.03 and SV8100 Version 4.01 and lower).

Mobile Extension and UCB (Unified Communications for Business) are supported within

the same system. (UCB 5.1, TSP 4.0 and SV8100 Version 5000 or higher).

Calls on Mobile Extension can be easily picked up from a telephone in the SV8100 system.

This is done via a Barge-In key (34+Mobile Ext# or 34+*) * will Barge in to the Extension

that Call Forward Both Ring is set to. If no Forward Both Ring is set, the key will act as a

basic Barge-In key. (Version 5000 or higher required)

Callback to Cell Phone

Callback to Cell Phone allows the user to make an incoming call to a system then hang up before the

system answers (like a one ring call), then the system calls back to the calling Cell Phone using a

pre-programmed number. The advantage is to reduce Cell Phone charges for calls on a mobile

extension system.

After receiving a call back on a Cell Phone, the user can call another extension or make an outgoing call

via the system using the mobile extension function.

Mobile Extension

Figure 2-31 Example – Callback to Cell Phone