Function Select Dial "Dial - FUTABA 1M23N20718 Instruction Manual

Function Select Dial "DIAL"

This function allows selection of the function performed by the digital dial (DL1/DL2/
DL3) and digital trimmers (DT1/DT2/DT3), step amount adjustment, and operating di-
rection reversal.
- The table below lists the functions that can be assigned to each dial and digital trimmer.
The assigned function is also displayed on the opening screen together with the current ad-
justment value. They are displayed in DL1, DL2, DL3, DT1, DT2, and DT3 order, from top
to bottom.
- The step amount can be adjusted. The table below shows the relationship between set value
and step amount.
- The operation direction can be reversed. (NOR/REV)
Calling the setup screen
*Calling from menu screen
(Opening Screen)
MENU 1
MENU 2
Press t
* When the direc t c all but ton
is set, the setup screen is also
called by the following method:
(Opening Screen)
DIRECT SEL
Press the button set
at this function.
Function select dial setup
1
(Setting Dial selection)
Select the item you want to set by (JOG) button up, down,
left, or right operation.
2
(To select or change a function for Dial)
Select one of the functions for "DIAL" by pressing (+) or (-) button.
(To change the step amount)
Use the (+) or (-) button to set the step amount.
(When changing the direction of operation)
Use the (+) or (-) button to dial the direction.
3
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
90
Menu screen call
by button
MENU1/2 selection
by button
Select the function
by button
he button
Press t
he button
* blinks at the current setup item.
Function Select Dial "DIAL"
button
Direction of operation setting
Step amount setting
Function selection
Setup item selection
- Select by (JOG) button up,
down, left or right operation.
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Press the (+) and (-) buttons
simultaneously (approx. 1 sec)
to return to the initial screen.
Initial value:
DL1 :"D/R", "2", "NOR"
DL2 :"ATL", "2", "NOR"
DL3 :"OFF"
DT1 :"ST-TR", "2", "NOR"
DT2 :"TH-TR", "2", "NOR"
DT3 :"OFF"