Servo View "Servo - FUTABA 1M23N20718 Instruction Manual

Servo View "SERVO"

Servo operation of each channel can be checked. Operation of the steering angle adjust-
ment, when a mixing function was set, etc. can be easily checked. The servo view can
also be displayed on the initial screen by using the system function (See page 108).
The neutral position of the throttle channel varies depending on the modes defined by
the "THR-MODE". The screen shown below shows an example of "F50/B50" in the
"NORMAL" mode.
Calling the setup screen
*Calling from menu screen
(Opening Screen)
MENU 1
MENU 2
Press t
* When the direc t c all but ton
is set, the setup screen is also
called by the following method:
(Opening Screen)
DIRECT SEL
Press the button set
at this function.
Ending the "SERVO" screen
1
When ending servo operation checks, return to the initial
screen by pressing the (END) button twice (for function menu
screen, press the (END) button once).
122
Menu screen call
by button
MENU1/2 selection
by button
Select the function
by button
he button
Press t
he button
100% position 100% position
Servo view "SERVO"
Steering operation
Throttle operation
Channel 3 operation
Channel 4 operation