FUTABA 1M23N20718 Instruction Manual page 129

Table of Contents

Advertisement

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATE-
MENT (for U.S.A.)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a residential in stallation.
This equipment generates, uses and can radiate radio frequency energy and, if not in-
stalled and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following
measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the re-
ceiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
To assure continued FCC compliance:Any changes or modifications not expressly ap-
proved by the grantee of this device could void the user's authority to operate the equip-
ment.
Exposure to Radio Frequency Radiation
To comply with FCC RF exposure compliance requirements, a separation distance of
at least 20 cm must be maintained between the antenna of this device and all persons.
This device must not be colocated or operating in conjunction with any other antenna or
transmitter.
FUTABA CORPORATION
Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba 299-4395, Japan
©FUTABA CORPORATION 2010, 12 (3)
129

Advertisement

Table of Contents
loading

This manual is also suitable for:

4pk-2.4g

Table of Contents