FUTABA 1M23N20718 Instruction Manual page 93

LAP TIMER function
- The LAP TIMER can memorize each lap time of each switch operation. (98 laps)
- The race time can be set. Switch operation after the set
time by alarm has elapsed automatically stops the timer..
Prealarm can also be set. The passage of time is announced
by sounding of a buzzer (beeps) each minute after starting.
-Alarm :Generates a beep at the set time.
Prealarm :Starts sounding the set time (second) before the alarm. (beeps)
- The first start operation can be linked with the throttle trigger.
(LAP TIMER operation)
- When lap timer is selected, the number of laps (LAP) and the lap memory No. (No.)
and current lap time (TIME) are displayed on the setup screen.
- Number of laps (LAP):Counts up each time the switch is pressed after starting. The numbers blink
for 3 seconds after the switch was pressed. To prevent erroneous counting, switch operation is not
accepted during this period..
- Lap memory No. (No.):Each lap time is memorized in a lap memory. The lap times are written se-
quentially from the number after the preceding data. After lap memory "No. 100", the lap No. returns
to "No. 1".
- The lap time data memorized in the lap memory can be checked at the lap list (See p. 97) screen.
- Lap time (TIME):During the first 3 seconds, the last lap time is displayed and then the current lap
time is displayed. At starting, "0" is displayed for 3 seconds.
LAP NAVIGATE timer function
- This function sounds a buzzer at a fixed interval after the timer starts. Since only the
buzzer can be restarted when the switch is pressed during timer operation, this function
can be used as the training run, etc. target time. (Lap navi-
gation alarm) The passage of time is announced by sound-
ing of a buzzer (beeps) every minute after starting.
- The first start operation can be linked with the throttle
trigger.
- The alarm sounds (alarm/prealarm) can be set separately from the fixed interval buzzer.
- Alarm :Generates a beep at the set time (minutes).
- Prealarm :Alarm advance announcement sound. Sounding starts the set time (seconds) before the
alarm. (beeps)
- After starting, the timer is enabled and can be stopped by switch even when the display
switches to another screen.
LAP TIMER
LAP NAVIGATE timer
Timer Function "TIMER"
93