System Functions "Systm; Battery Type Setting; Liquid Crystal Screen Backlighting Display Mode Setup; Setting Of On Time - FUTABA 1M23N20718 Instruction Manual

System Functions "SYSTM"

The graphic liquid crystal screen display mode, buzzer sound, LED display mode and
initial screen display mode can be set.
The system function setup items cannot be set for each model. (Second condition can be
set for each model.)
- Battery type setting (NiMH5 LiFe2, DRY 4CELL)
The T4PKS can use dry cell batteries (alkaline battery recommended) with the option-
al battery box, but the low battery alarm setting is different from that of a recharge-
able battery. Therefore, always set the battery type matched to the power source used.
Especially, when using a Futaba rechargeable type battery, always set the battery type
to "NiMH5 LiFe2". If the T4PKS is used at "DRY 4CELL" setting, the time from low
battery alarm to stopping of the system will become extremely short.

- Liquid crystal screen backlighting display mode setup

(OFF, ON at button operation, normally ON)
- Setting of ON time (1~30 secs) when [ON at button operation] was selected above.
- Jog button LED mode setup
- Liquid crystal screen contrast adjustment (20 steps)
- Buzzer sound tone adjustment (OFF, 100 steps)
- LED display color setup (OFF, 7 colors)
- Initial screen display mode setting
("Futaba" display, timer display, servo display, Users name, trim/dial)
When "Futaba", "TIMER", "SRV-
VIEW", "USR-NAME","4WS-TYPE"
or "TRM/DIAL" was selected, this
part is displayed.
- Second condition setting (INH, ACT)
To use second condition, switch setting by function select switch (page 88) is nec-
essary, in addition to ACT (active) setting by this system.
- The power off forgotten alarm setting (OFF, 10 m)
- 2.4GHz band setting (GENERAL, FRANCE)
Select "GENERAL", except inside France.
110
(NiMH5 LiFe2)
(Futaba)
System Functions "SYSTM"
(DRY 4CELL)
Model
(TRM/DIAL)
name
When "TRM/DIAL" was selected,
the trim DT1, DT2, and DT3 and
dial DL1, DL2, and DL3 informa-
tion is enlarged and displayed.
* Voltage display
When BATT-TYP is set for dry
cell battery (DRY 4CELL), the
voltage display of each screen
will be displayed by this mark.
RF display
When signals are be-
ing transmitted, "RF"is
displayed. When signals
are not being transmitted,
"DISP" is displayed.
Receiver type display
The type currently operat-
ing is displayed. ("C1"/"C2")
Servo response display
The mode currently operat-
ing is displayed.
("HIGH"/"NOR")