Function Select Trim Dial "Trim Dial - FUTABA 4PL-2.4GHZ Instruction Manual

Function Select Trim Dial "TRIM DIAL"

Selection of the function to be performed by digital trim (DT1, DT2, DT3, DT4)
and dial (DL1) and step amount adjustment and operation direction reversal can be
performed by this function.
- The functions that can be assigned to dial and digital trim are listed on the next page.
- The step amount can be adjusted. (The relationship between set value and step
amount is shown in the table on the next page.)
- The direction of operation of the servos can be reversed. (NOR/REV)
Display the function select trim/dial screen by as follows:
Select MENU
(HOME screen)
Function select dial setting
1
(Setting dial/trim selection)
Select the dial or trim you want to set by (UP) or (DN) button.
2
(Function setting)
Select the function with the (+) or (-) button.
- Refer to the list on the next page for the abbreviations of the
functions.
(Step amount setting)
Select the step amount you want to set by
(UP) or (DN) button. Set the step amount
with the (+) or (-) button.
- Refer to the next page for the relationship between set value and step amount.
3
When ending setting, return to the DIAL SW screen by
pressing the (CT) button. To return to the menu screen, se-
lect <MENU> by (UP) or (DN) button and press the (CT) but-
ton and to return to the HOME screen select <HOME> by (UP)
or (DN) button and press the (CT) button.
60
CT
(MENU screen)
Function Select Trim Dial "TRIM DIAL"
CT
(DIAL SW screen)
CT
(Function Trim Dial screen)
Function selection
Step amount setting
Direction of operation setting
Adjust button
Adjust with the (+) and (-) but-
tons.
- Return to the initial value "2" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.