FUTABA 1M23N20718 Instruction Manual page 67

Start function adjustment
(Preparation)
- Select the setting item "MODE" by (JOG) button up or down
operation. Press the (+) or (-) button and select "AT&SW".
- Select setup item "TG.P" and make the following adjustments.
Setup items
ATS : READY setting
TG.P : Throttle position
PRST : Preset position
MODE : Function selection
Setup item selection
- Select by (JOG) button up or down operation.
1
(Throttle position setup)
Set the throttle position by pressing the (+) or (-) button.
2
(Preset position setup)
Select the setting item "PRST" by (JOG) button up or down
operation, and use the (+) and (-) buttons to set the preset
position of the throttlle servo.
"B100" ~ "B1" :Brake side
"0" :Neutral
"F1" ~ "F100" :Forward side
Setting Example: (When ESC used with an electric car)
Set the preset position to F75% at EPA100%.
3
("READY" setting)
Select the setting item "ATS" by (JOG) button up or down op-
eration, and press the (+) and (-) buttons simultaneously for
about 1 second. "READY" blinks on the screen and the sys-
tem enters the READY state. Throttle trigger operation starts
the function.
4
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
-If the throttle trigger is moved to the set position while "READY" is flashing, the
throttle servo will move to the set position. The throttle operation wait state is reset
when the throttle trigger is returned.
-When using the Start function, always set the function by performing step 3 above
each time.
Start Function, Engine Cut "START"
Setup item selection
- Select by (JOG) button up or
down operation.
When the trigger is moved to the
HI side, and the trigger position
is exceeded, " " is displayed in
front of the number.
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Trigger position (TG.P)
5 ~ 95
Initial value: 5
Preset position (PRST)
B100 ~ B1, 0, F1 ~ F100
Initial value: 0
READY setting (ATS)
OFF : off state
READY : Ready state
ACT : on state
67