Camshaft Installation - KYMCO People Service Manual

6. CYLINDER HEAD/VALVES

CAMSHAFT INSTALLATION

Turn the A.C. generator flywheel so that the
"T" mark on the flywheel aligns with the index
mark on the right crankcase cover.
Keep the round hole on the camshaft gear
facing up and align the punch marks on the
camshaft gear with the cylinder head surface
(Position the intake and exhaust cam lobes
down.) and install the cam chain over the
camshaft gear.
Install the dowel pins.
Install the camshaft holder, washers and nuts
on the camshaft holder.
Tighten the four cylinder head nuts and the
two bolts between the cylinder head and
cylinder.
Torque: Cylinder head cap nut: 24.5N-m
Cylinder & cylinder head bolt: 7.8
11.8N-m
x Apply engine oil to the threads of the
cylinder head cap nuts.
x Diagonally tighten the cylinder head
cap nuts in 2 3 times.
x First tighten the cylinder head cap nuts
and then tighten the bolts between the
cylinder and cylinder head to avoid
cracks.
PEOPLE/PEOPLE S 250
Cam Chain
Punch Marks
Camshaft Gear
Cam Chain
Cap Nuts
Bolts
Camshaft Gear
Dowel Pins
Camshaft
Camshaft Holder
6-10