Fuel Pump Installation; Fuel Tank Removal - KYMCO People Service Manual

13. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK

FUEL PUMP INSTALLATION

Install the fuel pump and secure it with the
two nuts.
Connect the fuel pump inlet, outlet and
vacuum tubes.
Install the met-in box and carrier.
Install the body cover, center cover and rear
fender A.
Measure the fuel pump output.
Start the engine and disconnect the fuel
outlet tube and place a clean container under
the tube to check the fuel output.
Output: 33cc/1800rpm/10 seconds .

FUEL TANK REMOVAL

Remove the floor board. ( Ö 2-7)
Remove four nuts at the tank shield and
remove the tank shield.
PEOPLE/PEOPLE S 250
Outlet Tube
Nuts
Fuel Pump
Nuts
Vacuum Tube
Inlet Tube
Outlet Tube
Container
Tank Shield
13-20