Starter Motor - KYMCO People Service Manual

18. STARTING SYSTEM
Check if the needle bearing in the front cover
turns freely and has no excessive play.
Replace if necessary.
Check the dust seal for wear or damage.
ASSEMBLY
Apply grease to the dust seal in the front
cover.
Install the brushes onto the brush holders.
Apply a thin coat of grease to the two ends of
the armature shaft.
Insert the commutator into the front cover.
Install a new O-ring to the front cover.
Install the starter motor case, aligning the tab
on the motor case with the groove on the front
cover.
Tighten the starter motor case screws.
INSTALLATION
Connect the starter motor cable.
Check the O-ring for wear or damage and
replace if necessary.
Apply grease to the O-ring and install it to the

starter motor.

Tighten the two mounting bolts.
18-5
PEOPLE/PEOPLE S 250
Bushing
Dust Seal
Motor Case
Mark
O-ring
Motor Case
Starter Motor Cable
O-ring