Service Information - KYMCO People Service Manual

5. ENGINE REMOVAL/INSTALLATION

SERVICE INFORMATION

GENERAL INSTRUCTIONS
x A floor jack or other adjustable support is required to support and maneuver the engine. Be
careful not to damage the motorcycle body, cables and wires during engine removal.
x Use shop towels to protect the motorcycle body during engine removal.
x Drain the coolant before removing the engine.
x After the engine is installed, fill the cooling system with coolant and be sure to bleed air from the
water jacket. Start the engine to check for coolant leaks.
x Before removing the engine, the rear brake caliper must be removed first. Be careful not to
bend or twist the brake fluid tube.
SPECIFICATIONS
Engine oil capacity: at disassembly: 1.1 liter
TORQUE VALUES
Rear shock absorber upper mount bolt
Rear shock absorber lower mount bolt
Rear axle nut
Engine hanger bolt (frame side)
Engine hanger bolt (ENG. side)
Rear caliper holder bolt
Exhaust muffler pipe nut
Exhaust muffler bolt
Rear fork bolt
5-1
35 45N-m
35 45N-m
110 130N-m
45 55N-m
45 55N-m
29 35N-m
18 22N-m
32 38N-m
29 35N-m
PEOPLE/PEOPLE S 250