Cylinder Head Cover Removal; Camshaft Removal - KYMCO People Service Manual

6. CYLINDER HEAD/VALVES

CYLINDER HEAD COVER REMOVAL

Remove the met-in box, carrier. ( Ö 2-6)
Remove the body cover, center cover and
rear fender A. ( Ö 2-6)
Disconnect the secondary air inlet tube
connector and breather hose (air cleaner).
( Ö 5-2)
Remove the cylinder head cover four bolts
and two nuts attaching the secondary air inlet
duct.
Remove the cylinder head cover.

CAMSHAFT REMOVAL

Turn the A.C. generator flywheel so that the
"T" mark on the flywheel aligns with the index
mark on the right crankcase cover.
Hold the round hole on the camshaft gear
facing up and the location is the top dead
center on the compression stroke.
Remove the cam chain tensioner cap bolt.
Turn the cam chain tensioner screw
clockwise to tighten it.
Remove the two bolts attaching cam chain
tensioner and the tensioner.
First remove the two bolts between the
cylinder head and cylinder.
Then, remove the four cap nuts and washers
on the camshaft holder.
x Diagonally loosen the cylinder head
cap nuts in 2 or 3 times.
PEOPLE/PEOPLE S 250
Cylinder Head Cover
Bolt
Cam Chain Tensioner
Tensioner Screw
Cap Nuts
Bolts
Bolts
Nuts
Round Hole
Bolts
Camshaft Holder
6-4