Flywheel Installation - KYMCO People Service Manual

10. A.C. GENERATOR/STARTER CLUTCH
Install the starter idle gear and shaft.
Install the starter driven gear onto the
crankshaft.

FLYWHEEL INSTALLATION

Install the flywheel onto the crankshaft by
aligning the key on the crankshaft with the
groove in the flywheel.
x Before installation, check and make
sure that the inside of the flywheel is
not contaminated.
Install washer and nut.
Hold the flywheel with the flywheel holder
and tighten the flywheel nut.
Torque: 53.9 63.7N-m
remove the flywheel nut and washer.
Special
Flywheel holder
Shaft
Key
Flywheel Holder
E021
PEOPLE/PEOPLE S 250
Starter Idle Gear
Starter Driven Gear
Flywheel
Groove
10-8