1F-14 Engine Cooling System:
Water Pump Disassembly and Assembly
Refer to "Water Pump Removal and Installation
(Page 1F-13)".
Disassembly
1) Remove the air vent bolt (1) if necessary.
2) Remove the water pump case (2).
3) Remove the O-ring (3).
4) Remove the impeller securing bolt by holding the
impeller with a water pump pliers.
5) Remove the mechanical seal ring (4) and rubber
seal (5) from the impeller (3).
5
4
B718H11606029
1
2
I718H1160054-01
3
I718H1160012-01
3
I718H1160013-01
6) Remove the impeller shaft (6) and washer (7).
7
6
7) Remove the mechanical seal with the special tool.
NOTE
If there is no abnormal condition, the
mechanical seal removal is not necessary.
Special tool
(A): 09921–20240 (Bearing remover set)
8) Remove the oil seal.
NOTE
If there is no abnormal condition, the oil seal
removal is not necessary.
I718H1160014-01
(A)
I718H1160055-01
I718H1160016-01