Pair Reed Valve Removal And Installation; Pair Control Solenoid Valve Removal And Installation; Pair System Inspection - Suzuki GSF1250 Service Manual

1B-6 Emission Control Devices:

PAIR Reed Valve Removal and Installation

Removal
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
2) Drain engine coolant and remove the thermostat
connector. Refer to "Thermostat Connector /
Thermostat Removal and Installation in Section 1F
(Page 1F-9)".
3) Disconnect the hoses (1) and remove the PAIR reed
valve covers (2).
1
2
4) Remove the PAIR reed valves (3).
3
Installation
Install the PAIR reed valve in the reverse order of
removal. Pay attention to the following points:
• Install the PAIR reed valves (1) as shown.
• Apply thread lock to the bolts and tighten them to the
specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
PAIR reed valve cover bolt (a): 11 N·m (1.1 kgf-m,
8.0 lb-ft)
B718H11206008
1
2
I718H1120023-01
3
I718H1120029-01
PAIR Control Solenoid Valve Removal and
Installation
Removal
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
2) Drain engine coolant and remove the thermostat
connector. Refer to "Thermostat Connector /
Thermostat Removal and Installation in Section 1F
(Page 1F-9)".
3) Disconnect the PAIR control solenoid valve coupler
(1) and PAIR hoses (2).
4) Remove the PAIR control solenoid valve (3).
2
1
Installation
Install the PAIR control solenoid valve in the reverse
order of removal. Pay attention to the following point:
• Connect the PAIR control solenoid valve coupler and
PAIR hoses securely. Refer to "PAIR System Hose
Routing Diagram (Page 1B-4)".

PAIR System Inspection

PAIR Hose
1) Remove the fuel tank. Refer to "Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)".
(a)
1
I718H1120042-01
B718H11206001
2
3
I718H1120007-02
B718H11206002