Sprocket Mounting Drum Dust Seal / Bearing Removal And Installation - Suzuki GSF1250 Service Manual

3A-6 Drive Chain / Drive Train / Drive Shaft:
Sprocket Mounting Drum Dust Seal / Bearing
Removal and Installation
Removal
1) Remove the rear sprocket mounting drum assembly
from the rear wheel hub. Refer to "Rear Sprocket /
Rear Sprocket Mounting Drum Removal and
Installation (Page 3A-4)".
2) Remove the retainer (1).
3) Remove the sprocket mounting drum dust seal (2)
using the special tool.
Special tool
(A): 09913–50121 (Oil seal remover)
2
4) Remove the sprocket mounting drum bearing using
the special tool.
Special tool
(B): 09913–70210 (Bearing installer set)
Installation
B718H13106005
1) Apply grease to the bearing before installing.
1
2) Install the bearing (1) and dust seal (2) to the
I718H1310029-01
(A)
I718H1310020-02
3) Apply grease to the dust seal lip.
(B)
I718H1310025-01
CAUTION
!
The removed dust seal and bearing must be
replaced with new ones.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
sprocket mounting drum using the special tool.
CAUTION
!
The sealed cover of the bearing must face
outside.
Special tool
(A): 09913–70210 (Bearing installer set)
(A)
1
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
I649G1310020-02
(A)
2
I718H1310021-03
I718H1310022-02