Suzuki GSF1250 Service Manual page 302

1E-12 Engine Lubrication System:
• Install the oil pump.
NOTE
Set the oil pump shaft end "A" to the water
pump shaft.
• Tighten the oil pump mounting bolts to the specified
torque.
Tightening torque
Oil pump mounting bolt (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
• Install the washer (1) and pin (2).
NOTE
Be careful not to drop the washer (1) and pin
(2) into the crankcase.
1
(a)
2
• Install the oil pump driven gear (3) and snap ring (4).
CAUTION
!
Never reuse a snap ring.
Special tool
: 09900–06107 (Snap ring pliers)
"A"
• Install the washer (5) and thrust washer (6) onto the
I718H1150058-01
• Install the oil pump drive sprocket (7) to the
(a)
• Pass the chain between the oil pump drive and driven
• Install the spacer (8).
I718H1150059-01
• Reinstall the clutch. Refer to "Clutch Installation in
4
countershaft.
NOTE
The chamfer side "B" of thrust washer faces
inside.
"B"
6
countershaft.
NOTE
Teeth "C" on the sprocket must face the
clutch side.
sprockets.
"C"
7
Section 5C (Page 5C-14)".
3
I718H1150060-01
5
I718H1150061-01
8
I718H1150062-01