• Tighten the cushion lever, cushion rod and rear shock
absorber mounting nut to the specified torque.
Tightening torque
Cushion rod mounting nut (b): 78 N·m (7.8 kgf-m,
56.5 lb-ft)
Cushion lever mounting nut (c): 78 N·m (7.8 kgf-
m, 56.5 lb-ft)
Rear shock absorber mounting nut (d): 50 N·m (
5.0 kgf-m, 36.0 lb-ft)
(c)
(b)
(d)
(b)
(d)
I718H1230040-02
I718H1230027-02
I718H1230041-01
Swingarm Related Parts Inspection
Refer to "Swingarm / Cushion Rod Removal and
Installation (Page 2C-7)".
Spacers
1) Remove the spacers from the swingarm.
2) Inspect the spacers for wear and damage. If any
defects are found, replace the spacers with new
ones.
Chain Buffer
Inspect the chain buffer for wear and damage. If any
defect is found, replace the chain buffer with a new one.
Swingarm Bearing and Cushion Rod Bearing
1) Insert the spacers into bearings.
2) Check the play by moving the spacers up and down.
If excessive play is noted, replace the bearing with a
new one. Refer to "Swingarm Bearing Removal and
Installation (Page 2C-10)".
Rear Suspension:
2C-9
B718H12306012
I718H1230028-01
I718H1230029-01
I718H1230030-01