Suzuki GSF1250 Service Manual page 409

Installation
CAUTION
!
The removed bearings must be replaced with
new ones.
1) Press the swingarm cushion rod bearings with the
special tool.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
(A): 09924–84521 (Bearing installer set)
(A)
2) Install the center spacer.
3) Press the bearings into the swingarm pivot with the
special tool.
NOTE
When installing the bearing, stamped mark
on the bearing must face outside.
Special tool
4) Apply grease to the bearings.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
I718H1230036-01
5) Install the swingarm. Refer to "Swingarm / Cushion
Rod Removal and Installation (Page 2C-7)".
6) Install the rear wheel assembly. Refer to "Rear
Wheel Assembly Removal and Installation in Section
2D (Page 2D-16)".
Rear Suspension:
(B): 09941–34513 (Steering race installer)
2C-11
(B)
I649G1230039-04
I718H1230038-03