3A-2 Drive Chain / Drive Train / Drive Shaft:
Engine Sprocket Removal and Installation
Removal
1) Support the motorcycle with the center stand.
2) Remove the engine sprocket outer cover (1).
1
3) Remove the regulator/rectifier bracket mounting
bolts.
4) Disengage the gearshift link arm (2) by removing the
bolt.
NOTE
Mark the gearshift shaft head at which the
gearshift link arm slit set for correct
reinstallation.
B718H13106002
I718H1310001-02
I718H1310033-01
2
I718H1310034-01
5) Remove the speed sensor (3).
6) Remove the engine sprocket inner cover (4) along
with the clutch release cylinder.
7) Remove the speed sensor rotor (5) by removing its
bolt while depressing the rear brake pedal.
8) Remove the engine sprocket nut (6) while
depressing the rear brake pedal.
9) Remove the washer (7).
3
4
I718H1310003-05
5
I718H1310005-04
6
7
I718H1310006-04