Suzuki GSF1250 Service Manual page 43

4) Install a new oil filter. Turn it by hand until you feel
that the oil filter O-ring contacts the oil filter mounting
surface. Then, tighten the oil filter two full turns (or to
specified torque) using the special tool.
NOTE
To properly tighten the oil filter, use the
special tool. Never tighten the oil filter by
hand only.
Special tool
(A): 09915–40611 (Oil filter wrench)
Tightening torque
Oil filter (a): 20 N·m (2.0 kgf-m, 14.5 lb-ft)
1
(a)
5) Add new engine oil and check the oil level is as
described in the engine oil replacement procedure.
Necessary amount of engine oil
Oil change: 3 000 ml (3.2/2.6 US/lmp qt)
Oil and filter change: 3 500 ml (3.7/3.1 US/lmp qt)
Engine overhaul: 3 700 ml (3.9/3.3 US/lmp qt)
Throttle Cable Play Inspection and Adjustment
Inspect throttle cable play
Initially at 1 000 km (6 000 miles, 2 months) and
every 6 000 km (4 000 miles, 12 months) thereafter.
Inspect and adjust the throttle cable play "a" as follows.
Throttle cable play "a"
2.0 – 4.0 mm (0.08 – 0.16 in)
(A)
I718H1020026-01
B718H10206009
" a "
I718H1020063-01
Maintenance and Lubrication:
1) Loosen the lock-nut (1) of the throttle pulling cable
(2).
2) Turn the adjuster (3) in or out until the throttle cable
play "a" (at the throttle grip) is between 2 – 4 mm
(0.08 – 0.16 in).
3) Tighten the lock-nut (1) while holding the adjuster
(3).
1
2
WARNING
!
After the adjustment is completed, check that
handlebar movement does not raise the
engine idle speed and that the throttle grip
returns smoothly and automatically.
Throttle Valve Synchronization
Inspect throttle valve synchronization
Every 12 000 km (7 500 miles, 24 months)
Inspect the throttle valve synchronization periodically.
Refer to "Throttle Valve Synchronization in Section 1D
(Page 1D-15)".
PAIR System Inspection
Inspect PAIR system
Every 12 000 km (7 500 miles, 24 months)
Inspect the PAIR (air supply) system periodically. Refer
to "PAIR System Inspection in Section 1B (Page 1B-6)".
Cooling System Inspection
Inspect cooling system
Every 6 000 km (4 000 miles, 6 months)
Replace engine coolant
Every 2 years
Engine Coolant Level Inspection
1) Keep the motorcycle upright with the center stand.
2) Remove the seat. Refer to "Exterior Parts
Construction in Section 9D (Page 9D-2)".
0B-12
3
I718H1020064-02
B718H10206011
B718H10206012
B718H10206031