1J-10 Charging System:
1) Remove the aluminum tape (1) which seals the
battery filler holes "A".
2) Remove the caps (2) from the electrolyte container.
NOTE
• Do not remove or pierce the sealed areas
"B" of the electrolyte container.
• After filling the electrolyte completely, use
the removed cap (2) as sealing caps of
battery-filler holes.
2
3) Insert the nozzles of the electrolyte container (3) into
the electrolyte filler holes of the battery.
4) Hold the electrolyte container firmly so that it does
not fall.
NOTE
Do not allow any of the electrolyte to spill.
3
1
"A"
I649G11A0039-03
"B"
I649G11A0040-03
I649G11A0041-03
5) Make sure that air bubbles (4) rise to the top of each
electrolyte container, and leave in this position for
about more than 20 minutes.
4
NOTE
If no air bubbles come out from a filler port,
tap the bottom of the electrolyte container
two or three times.
Never remove the container from the battery.
I649G11A0042-03
I310G11A0024-01