Roland VersaCamm SP-540V Service Notes page 85

17 Connect the PANEL CABLE to the PANEL BOARD,
and fix the PANEL COVER.
18 Turn on the MAIN POWER SW. Then, turn on the SUB
POWER SW while pressing the Left, Right and Down
keys to enter the SERVICE MODE.
Select [CAP&WIPER CTRL] > [CAP] > [OPEN], and
19
press the [ENTER] key. The CAPPING UNIT moves
down and allows you to move the HEAD CARRIAGE by
hand.
Move the HEAD CARRIAGE in a whole width of the GUIDE
20
RAIL several times to remove the slack in the CARRIAGE
WIRE.
Then, carry out the following adjustments.
1. WIRE TENSION ADJUSTMENT
2. LIMIT POSITION & CUT DOWN POSITION INITIALIZE
3. LINEAR ENCODER SETUP
4. CUTTING QUALITY CHECK
[ ], [
MENU
SERVICE MENU
SERVICE MENU
CAP&WIPER CTRL
CAP&WIPER CTRL
CAP
CAP
OPEN
3-40
PANEL COVER
], [ ] + POWER ON
[MENU] key
[ ]
[ ]
[ENTER]