Roland VersaCamm SP-540V Service Notes page 106

SERVICE MENU
WIPER CHECK
Finished
This menu is used for checking the Wiper movement. It moves the wiper back and forth 20 times after moving
aside the Tool carriage. If the machine detects the motor loses steps, an error message appears. But the
machine sometimes can't detect it. It is necessary that the technician himself/herself checks the wiper motor
doesn't lose steps by seeing the movement and hearing the sound.
SERVICE MENU
CHANGE INKTYPE
It is used for changing the Ink type compulsorily. Head Cleaning or Ink Fill won't be performed as in the
User's Mode. It is used for correcting the Ink type in case it is set to a wrong type by mistake.
*1 It is displayed when white ink is used.
*2 It is displayed when sublimation ink is used.
SERVICE MENU
CAP&WIPER CTRL
It is used for moving up / down the cap.
It is used for moving the wiper back and forth.
** Please make sure the position of the Cap and Wiper when you move the Carriage by hand.
Please make sure the position of the Carriage (especially Heads) when you move the Cap and Wiper by hand.
SERVICE MENU
PORT CHECK
This menu is used for checking the Data Input from the Eithernet.
The Check Sum and the size of the input data will be displayed on the bottom row.
Check Sum will be indicated on the left side and the size of the input data will be indicated on the right
side. The Check Sum and the size of the input data will be cleared when pressing the [ENTER] key.
SERVICE MENU
TIME OUT
This menu is used for setting the Time Out.
If the data transmission from the host stops for a set time, the machine recognizes that 1 printing has been
done. Default : NONE
SERVICE MENU
MAINTE. MSG.
This menu is used for setting the Maintenance time.
If the printing time reaches the set time, the Maintenance message appears.
SERVICE MENU
HEATER ADJUST
This menu is used for setting the offset value of print heater and dryer.
The heater is controlled based on the offset temperature.
NOW PROCESSING..
WIPER CHECK
FAILED !!
error (beep 2 times)
CHANGE INKTYPE
e SOL4 e SOL4
INK TYPE PIG 4 Pigment
DYE 4 Dye
e SOL4 (ECO-SOL)
e SOLW4 (ECO-SOL)*1
SUBL.4 *2
UNKNOWN Not being selected
CAP&WIPER CTRL
CAP
CAP&WIPER CTRL
WIPER
OPEN / UP
Make sure not to open the cap for a long time in order to prevent the ink from drying up.
It can be moved at two-level [FRONT / REAR].
DETECTING...
00: 0B
NETWORK
5A: 1024B
TIME OUT
10 sec 10 sec
MAINTE. MSG.
NONE 100 hours
HEATER ADJUST
PRINT HEATER
HEATER ADJUST
DRYER
4-9
CAP
OPEN
CAP
UP
WIPER
FRONT
WIPER
REAR
Waiting for Data Input
Data Input from the Eithernet
PRINT HEATER
0 -3
-5~+5
DRYER
0 -3
-5~+5
4