Roland VersaCamm SP-540V Service Notes page 181

*4
Not assured when the print heater or dryer is used.
*5
The following conditions must be satisfied:
Media type : 3M Scotchcal Mastercut Film
Roll media must be loaded on the shaft
[PREFEED] menu item must be set to [ENABLE]
Side margins : 25 mm or more for both the left and right margins
Front margin : 35 mm or more
Excluding stretching/contraction of the media
Range for assured repetition accuracy
For media with a width exceeding 610 mm : Length 4,000 mm
For media with a width of 610 mm or less : Length 8,000 mm
*6
Provided that media length is under 3000 mm
Temperature : 25 degrees C (77 degrees F)
Excluding possible shift caused by expansion/contraction of the media and /or by reloading the media
*7
Media type : Roland SV-G-1270G
Data size : 1,000 mm in the media-feed direction, 1,346 mm in the carriage-movement direction
No lamination
Automatic detection of crop marks at 4 points when media is reloaded
During cutting, [PREFEED] menu item must be set to [ENABLE]
Temperature : 25 degrees C (77 degrees F)
Excludes the effects of slanted movement and of expansion and contraction of the media
*8
Warm-up is required after power up. This may require 5 to 20 minutes, depending on the operation environment.
Depending on the ambient temperature and media width, the preset temperature fail to be reached.
*9
Operating environment
(%)
Humidity
(no condensation) 80
55
35
0 15 20
(59) (68)
Temperature
Use in an operating environment
with this range.
°C (°F)
27 32
(80.6) (89.6)
7-16