Roland VersaCamm SP-540V Service Notes page 138

Check the gap between the marks and cutting line.
4
The gap of the print&cut might be different.
depends on the position.
Input the values by pressing [
5
keys to minimize the gap between the print and the cut
at the 3 positions. An input is performed per 0.01mm
unit. (cutting position moves by this operation) Press
[ENTER] to save the adjustment value
To escape from the input screen of an
adjustment value, press the [MENU] button.
Please be careful that the adjustment value
changes if the [
pressed at this time.
For the check, press the [TEST CUT] key again and
6
perform the printing of a test pattern. Check the mark
printed / cut and gap of each mark and a cut line.
Adjustment has been completed if the quantity of the
gap in three points (the right, the left and middle) is the
minimum. If you can still see the large gap, repeat the
procedures 3-5.
], [ ], [ ] and [
], [ ], [ ] or [ ] key is
4-41
]
F: 0.40 ----
S:-0.50 ----
F: 0.40 +0.01mm
S:-0.50 -0.20mm
[ENTER]
F: 0.41 ----
S:-0.70 ----
-
F:
+
-
S:
The dotted line shows cutting line.
The dotted line shows cutting line.
4