21
From the menu (NOT from the service menu), select
[INK CONTROL] > [HEAD REPLACE], and press the
ENTER key.
22
Enter the SERVICE MODE and perform the following
adjustments.
1. THERMISTER CHECK
2. HEAD ALIGNMENT
3. HEAD INFORMATION CLEAR
4. CAP HEIGHT CHECK
5. TOOL / CROP MARK SENSOR POSITION
HOW TO CLEAR THE HEAD INFORMATION
After THERMISTER CHECK and HEAD ALIGNMENT,
clear the HEAD INFORMATION from the SERVICE
MENU > HISTORY MENU > HEAD GROUP.
When you replaced the left Head, select [CLEAR H1] and
press the ENTER key.
When you replaced the right Head, [CLEAR H2] and press
the ENTER key.
MENU
INK CONTROL
SERVICE MENU
HISTORY MENU
[
HISTORY MENU
MOTOR GROUP
[
HISTORY MENU
HEAD GROUP
3-8
INK CONTROL
EMPTY MODE
EMPTY MODE
STOP
INK CONTROL
FILL INK
INK CONTROL
PUMP UP
INK CONTROL
HEAD WASH
INK CONTROL
HEAD REPLACE
]
]
HEAD GROUP
CLEAR H1
HEAD GROUP
CLEAR H2
STOP