Canon iR1600 Service Manual page 466

CHAPTER 14 VERSION UP
c. After Finishing Downloading
1) Turn off the power switch of the machine.
2) Turn off the PC.
3) Disconnect the USB cable from the PC and the machine.
4) (If a network interface board is mounted, connect the USB cable to the network inter-
face able.) Mount the rear cover.
5) Turn on the power switch of the machine.
6) Press the User Mode key and the # key in the control panel to start service mode.
7) Using the cursor key
8) Using the cursor key
9) Execute the following in service mode: #12 CLEAR>ALL.
10) Enter the following in service mode: #5 TYPE.
11) Be sure to ensure that you set the country type to suit the communication
standard used in your country/region using the cursor key.
12) Press the OK key so that the entered type settings will be stored.
13) Press clear key to return the copying mode.
14) Store the data that has been cleared and data which has been returned to factory settings.
Executing 'ALL CLEAR' will not clear the various counter data and the
data stored under #6 SCANNER>7 CCD in service mode; i.e., you need not
store them newly.
Memo
14-16
/ , select '#13 ROM', and click 'OK'.
/ , check the version indicated under 'MAIN'.
COPYRIGHT© 2002 CANON INC. 2000 CANON iR1600/iR2000 REV.1 JAN. 2002