Canon iR1600 Service Manual page 198

CHAPTER 7 FIXING SYSTEM
10) Remove the 2 small stepped screws
[10] and the 2 large stepped screws
[11]. When removing the large stepped
screws [12], be sure to insert a hex key
(less than 2 mm in diameter) into the
screw hole [13] and loosen them by
turning the hex wrench.
1. After mounting the fixing
assembly, check to make
sure that the delivery lower
cover [14] is behind the rear
cover [15] as shown.
2. When mounting the fixing
assembly, you may find it
difficult to engage the fixing
roller gear. If such is the
case, release the locking le-
ver [16], to which the fixing
roller gear is linked.
7-14
[11]
A
[10]
[14]
COPYRIGHT© 2002 CANON INC.
[12]
A
[13]
F07-301-05
[15]
F07-301-06
[16]
F07-301-07
2000 CANON iR1600/iR2000 REV.1 JAN. 2002
[11]
A
[10]