Panasonic FP0 User Manual page 369

Error
Name
code
Configu-
ration
E29
parameter
error
Interrupt
E30
error 0
Interrupt
E31
error 1
Interrupt
E32
error 2
Multi-CPU
data
E33
unmatch
error
I/O status
E34
error
MEWNET-F
slave
E35
illegal unit
error
MEWNET-F
(remore
E36 I/O)
limitation
error
MEWNET-F
I/O
E37
mapping
error
Opera-
tion Description and steps to take
status
A parameter error was detected in the
Stops
MEWNET-W2 configuration area. Set
a correct parameter.
Probably a hardware abnormality.
Stops
⇒ Please contact your dealer.
An interrupt occurred without an
interrupt request . A hardware problem
Stops
or error due to noise is possible.
⇒ Turn off the power and check the
noise conditions.
There is no interrupt program for an
interrupt which occurred.
⇒ Check the number of the interrupt
Stops
program and change it to agree with
the interrrupt request..
This error occurs when a FP3/FP10SH
CPU2
is used as CPU2 for a multi-CPU
system.
Stops
⇒Refer to "Multi-CPU system Manual".
An abnormal unit is installed.
-FPΣ, FP-X, FP2,FP2SH and
FP10SH:
Check the contents of special data
register DT90036 and locate the
abnormal unit.Then turn off the power
Stops
and replace the unit with a new one.
-FP3:
Check the contents of special data
register DT9036 and locate the
abnormal unit. Then turn off the power
and replace the unit with a new one.
A unit, which cannot be installed on the
slave station of the MEWNET-F link
Stops
system,is installed on the slave station.
⇒Remove the illegal unit from the
slave station.
The number of slots or I/O points used
for MEWNET-F(remote I/O) system
exceeds the limitation.
Stops
⇒Re-configure the system so that the
number of slots and I/O points is within
the specified range.
I/O overlap or I/O setting that is over
the range is detected in the allocated
Stops
I/O and MEWNET-F I/O map.
⇒Re-configure the I/O map correctly
A
A A A A A A
A A A A A A
A A A
A
A
A
A:Available
A
A
A A A
A A A
A A
A A A
A A A
A A A
A A A
14-127