Changing Program Modes; Changing Modes In Fp Programmer Ii - Panasonic FP0 User Manual

FP0
Item
Operation of SSTP/STPE
each instruc-
tion
JP/LOOP/LBL
8.7.4

Changing Modes in FP Programmer II

Changing program modes

FP Programmer II is normally in PROG−EDIT mode which does not allow unintentional
rewriting of programs. To perform a rewrite during RUN, the mode must be changed to
RUN−EDIT mode.
Change the mode as shown below. After the rewrite, change back to PROG−EDIT
mode to prevent accidental rewriting.
Procedure for changing to RUN−EDIT mode
(−)
ACLR 1
OP
Procedure for changing to PROG−EDIT mode
(−)
ACLR 1
OP
FPWIN GR
Ladder symbol mode
A distance with the same
number cannot be defined
twice.
An SSTP instruction cannot
be written in a subprogram.
Be sure to write the instruc-
tion for setting the loop
number before LBL-LOOP
instructions.
4 ENT
4 ENT
8.7 Rewrite Function During RUN
FPWIN GR
Boolean mode
Writing and deletion of a single instruction is not
possible for a program with no step ladder area.
Write or delete both instructions simultaneously in
FPWIN GR ladder symbol mode.
In the case of an SSTP instruction only, writing and
deletion of a single instruction is possible for a pro-
gram with a step ladder area.
Write in the order: JP-LBL or LOOP-LBL.
Delete in the order: LBL-JP or LBL-LOOP.
1 WRT
0 WRT
Precautions During Programming
FP Programmer II
8 − 23