Setting The Skew On The Mls 608 D; Selecting The Mls 608 D Output Prepeak - Extron electronics MLS 608 D Series User Manual

Setting the Skew on the MLS 608 D

To adjust output skew between the MLS 608 D and the receiver:
1. Connect an oscilloscope (preferred) or a monitor (acceptable) to the
RGB output on the MTP/HDMI U R.
2. Apply a crosshatch test pattern to the inputs 1, 2, or 3 on the MLS 608 D.
3.
Use the test equipment or examine the video image with a critical eye to determine
which video signal (red, green, or blue) is most shifted to the left.
Within the DSP Configurator program, click View>Video
4.
I/O (or press <F4>) to access the MLS workspace view.
Double-click MTP on the output (right) side of the workspace
view. The Output MTP Settings dialog box appears (see
image at right).
5. While observing the oscilloscope or monitor, adjust the furthest
left video signal by using the up and down arrows for the
relevant signal color, and repeat as needed until all three colors
are aligned correctly
If using Input 4 — input skew adjustment
Follow the steps 1 to 3 as given in "Output skew", above. Then:
Within the DSP Configurator program, click View>Video I/O (or press <F4>) to
1.
access the MLS workspace view. Double-click MTP on the output (right) side of the
workspace view. The Input MTP Settings dialog box appears.
2.
Adjust the furthest left video signal by using the up and down arrows for the relevant
signal color, and repeat as needed until all three colors are aligned correctly.

Selecting the MLS 608 D Output PrePeak

1. Click View>Video I/O (or press <F4>); this changes the window to the MLS
workspace view. Double click on the MTP on the output (right) side of the workspace
view. The Output MTP Settings dialog box appears.
Toggle the Pre-peak box on or off as desired.
2.
NOTE:
.
For other video configurations, such as RGB delay, or input video format
swapping, see the DSP Configurator Help file.
MLS 608 D Series • Operation 41