Fax Defaults - Fuji Xerox DocuPrint CM405 df User Manual

Fax Defaults

Purpose:
To modify the defaults for the Fax menu.
NOTE:
• The FAX service cannot be used unless you set up a region code under Region. If Region is not set up, a message Set
the Country Code appears on the display.
• Values marked by an asterisk (*) are the factory default menu settings.
• Resolution
Purpose:
To specify the scan resolution to improve the output quality.
Values:
*
Standard
Fine
Super Fine
Photo
NOTE:
• Faxes scanned in the Super Fine mode transmit at the highest resolution supported by the receiving device.
• 2 Sided Scanning
Purpose:
To scan both sides of a sheet of paper.
Values:
*
1 Sided
2 Sided Binding of
Original
*1
This item is available only when 2 Sided Scanning is set to 2 Sided Printing in the Scan Defaults menu.
• Lighten / Darken
Purpose:
To adjust the density to make the copy lighter or darker than the original.
Values:
Darken +3
Darken +2
Darken +1
*
Normal
Lighten +1
Lighten +2
Lighten +3
330
Using the Operator Panel Menus and Keypad
Suitable for documents with normal sized characters.
Suitable for documents containing small characters or thin lines or documents printed
using a dot-matrix printer.
Suitable for documents containing extremely fine detail. The Super Fine mode is enabled
only if the remote machine also supports the Super Fine mode. See the notes below.
Suitable for documents containing photographic images.
Long Edge
*1 *
Binding
Short Edge
Binding
Works well with light print or faint pencil markings.
Works well with standard typed or printed documents.
Works well with dark print.
Scans one side of a document.
Scans both sides of a document to be bound by long edge.
Scans both sides of a document to be bound by short edge.