Fuji Xerox DocuPrint CM405 df User Manual page 60

18
Lightly pull the power cord to take up the slack of the cable.
19
Connect the other end of the power cord into the power source.
20
Connect other cables into the rear of the printer and turn on the printer.
NOTE:
• The printer will automatically detect the attached tray but will not detect the paper type.
21
Print the System Settings page to confirm the optional 550 sheet feeder is installed correctly.
Press the (System) button.
a
Select Report / List.
b
Select System Settings.
c
Select Print.
d
The System Settings page is printed.
22
Confirm Tray 2 (550 Sheet Feeder) is listed under Printer Options in the System Settings page.
If the feeder is not listed, turn off the printer, unplug the power cord, and re-install the optional 550 sheet feeder.
23
After loading paper in the optional 550 sheet feeder, specify the paper type from the printer operator panel.
Press the (System) button.
a
Select the Tools tab, and then select Tray Management.
b
Select Tray Settings.
c
Select Tray 2.
d
Select Size.
e
Select the desired paper size.
f
Select Type.
g
Select the desired paper type.
h
Select OK.
i
24
If you installed the optional 550 sheet feeder after installing the print driver, update your driver by following the
instructions for each operating system. If the printer is on a network, update the driver for each client.
60
Basic Operation