Setting The Switch For The "Multiflex" Cutting System - DURKOPP ADLER 580 Operating Instructions Manual

10.6 Setting the switch for the "Multiflex" cutting system

7 6 3 2 1
Caution: Danger of injury !
Turn the main switch off.
Set the switch for the cutting system only with the machine
switched off.
Standard checking
When the cutting block is at its upper position, the lower edge 2 of the
fork 1 should be on the same level as the lower edge of the switch 3.
There must be a distance of 2 mm between the switch 3 and the fork 1.
Correcting the switch height
–
Loosen screw 5.
–
Shift the plate 4 with the switch 3 upward.
–
Tighten screw 5.
Correction distance between the switch and the fork
–
Loosen the counter nut 6.
–
Set the switch 3 and the nut 7 in a way that a 2 mm distance is
kept.
–
Tighten the counter nut 6.
5 4 3
3
43