Transversal Motion Of The Fabric Support Plate - DURKOPP ADLER 580 Operating Instructions Manual

6.

Transversal motion of the fabric support plate

Caution: Danger of injury!
Exercise utmost caution when making adjustments with the machine
running.
Note
Please observe the necessary program setting as described in chapter 1.1.
Standard checking
The looper turret 3 must be in the centre of the fabric support plate 4.
When the automatic buttonholer is in reference position, the
dimensions X1 and X2 must be equal when the fabric support plate is
adjusted correctly.
The distance between reference switch 5 and switch sheet 6 must not
exceed 0.5 mm.
–
Switch the machine on.
–
Press key "F" at the control panel.
–
Enter code "2548".
–
Press key "OK".
The control switches to the technician level.
–
Select menu "Test functions".
–
Press key "OK".
–
Select menu "Sewing proc.".
–
Press key "OK".
–
Select menu "Start ref.".
–
Press key "OK"
The machine runs to its initial position.
–
Check the dimension X1 (right edge of the throat plate groove to
the left edge of the fabric support plate) with the vernier caliper 2.
–
Check the dimension X2 (left edge of the throat plate groove to the
right edge of the fabric support plate).
6 5
3
17