Menu Items Configuration Automatic Buttonholer; Loading Position; Menu Item Throw Width - DURKOPP ADLER 580 Operating Instructions Manual

29.4 Menu items configuration automatic buttonholer

29.4.1 Loading position (Load.pos.)
29.4.2 Menu item throw width (Zig Zag)
88
Via this menu item the desired loading position can be set.
Input: 0 ... 68 (mm)
Standard: 68
The value entered corresponds to the distance from the cutting point.
The value "0" corresponds to the cutting-open position.
The standard value is identical with the seam beginning position.
In this menu the throw width can be checked and with eyelet machines
it can also be set.
Caution: Danger of breakage !
The throw width must match the mechanical position
of the throw eccentric.
See chapter 2.3
Input: 1 = Narrow
2 = Wide